?>

Amplifiers

Model Shown:

PA1041-001

Outdoor SSPA
Click Image to Enlarge

L or S BAND, Dual L/S Band, Triple Output Dual Band, GaN Wideband Outdoor


WV Communications offers a full suite of standard and custom SGLS and USB Solid State Power Amplifiers (SSPA). This includes a wide power output range, 1:1 redundancy, and combining L&S band amplifiers using GaN Technology.

RF Characteristics
  • Frequency Range: 1750-1850MHz, 2025-2120MHz, 1900-2400MHz
  • RF Output Power: up to 2000 Watts CW
  • RF Output Level Adjust: 30dB typical in 0.1dB steps
  • RF Input Power: 0dBm nominal
  • Input/Output VSWR: 1.5:1 Maximum (Ref 50 Ohm)
  • Output Protection: No oscillation or damage into infinite VSWR at any Phase Angle (Internally Protected)
  • Noise Figure: 10dB Typical
  • Spurious Outputs: 60dBc Minimum
  • Harmonics: 20dBc maximum (>60dBc with optional High Power Output LPF)
RF Power Options
  • 25 Watts
  • 50 Watts
  • 100 Watts
  • 200 Watts
  • 300 Watts
  • 400 Watts
  • 500 Watts
  • 900 Watts
  • 2000 Watts
Controls & Reporting
  • Control Signals: Output Power Adjust (0.1dB steps)
  • Reported Signals: Forward and Reflected Power, Power in dBm or Watts, Temperatures, Current, Voltage, elapsed running time
Remote Communications Options
  • Serial Interface: RS232 or RS422
  • Ethernet UDP/IP
Power Supply Characteristics
  • AC Input Power: 115 or 230 VAC, 47-63 Hz Single or Three Phase
  • Efficiency: >40% Typical AC input to RF Output Power
Options
  • Control: Remote Interlock On/off Control via 24VDC/0.20A control signal
  • Safety Door Interlock Switch with over-ride and output for lamp indicator
  • Heater to extend lower operating temperature range to -55 Deg C
Specification Sheet Downloads